The triangular portion between any two adjacent arches and the tangent to their crowns, is

The triangular space formed between the extrados and the horizontal line drawn through the crown of an arch is known as

The triaxial apparatus is usually used for

The true and mean suns occupy the same meridian at the same time on

The true meridian of a place is the line in which earth’s surface is intersected by a plane through

The trunk of tree left after cutting all the branches is known as

The two important forces for a floating body are

The two point problem and three point problem are methods of

The type of aggregates not suitable for high strength concrete and for pavements subjected to
tension, is

The type of aggregates of same nominal size, which contain less voids when compacted, are

The type of arch generally constructed over a wooden lintel or over a flat arch for the purpose of carrying the load of the wall above is

The type of arch used for high class buildings where appearance is of prime importance, is known as

The type of ashlar masonry in which stones are finely chisel dressed and thickness of joints does not exceed 3 mm, is

The type of bearing plate used in all joints and on curves to give better bearing area to the rails is

The type of bond in a brick masonry containing alternate courses of stretchers and headers, is called

The type of bond in which every course contains both headers and stretchers, is called

The type of bond provided in brick masonry for carrying heavy loads is

The type of curves generally provided on highways, is

The type of flooring suitable for use in churches, theatres, public libraries and other places where noiseless floor covering is desired is

The type of footing which is used to transmit heavy loads through steel columns is

The type of joint commonly used at the junction of a principal rafter and tie beam in timber trusses is

The type of joint generally used in cast iron pipes, is

The type of pile which is driven at an inclination to resist inclined forces is known as

The type of pipe commonly used in water supply distribution schemes, is

The type of pointing in which a V-shaped projection outside the wall surface, is provided, is called

The type of pointing in which upper side of mortar joints is kept about 12 mm inside the face of the masonry and bottom is kept flushed with face of wall, is

The type of roof suitable in plains where rainfall is meagre and temperature is high is

The type of roof which slopes in two directions with a break in the slope on each side is known as

The type of sewer which is suitable for both combined and separate system is

The type of spike used for fixing chairs of bull headed rails to wooden sleepers is

The type of steel used for precision levelling staff, is

The type of stone masonry in which stones of same height are laid in layers, is called

The type of surveying which requires least office work is

The type of switch generally used for B.G. and M.G. tracks, is

The type of transition curves generally provided on hill roads, is

The type of valve which allows water to flow in one direction but prevents its flow in the reverse direction is

The type of valve which is provided to control the flow of water in the distribution system at street corners and where the pipe lines intersect is

The type of valve, which is provided on the suction pipe in a tube-well, is

The U.C. (uniformity coefficient) D60/D10 for the best filter media sand should be

The ultimate bearing capacity of a soil, is

The ultimate consolidation settlement of a soil is

The ultimate consolidation settlement of a structure resting on a soil

The ultimate Settlement of a soil is directly proportional to:

The ultimate tensile strength of structural mild steel is about

The under surface of an arch, is called

The underground sewers are more subjected to

The unit of dynamic viscosity in S.I. units is

The unit of force in C.G.S. system of units, is called

The unit of measurement is per quintal for the following:

The unit of Moment of Inertia of a body, is

The unit of surface tension is

The unit of viscosity is

The units of dynamic or absolute viscosity are

The units of kinematic viscosity are

The uplift pressure on the roof of an inverted syphon, is maximum when

The upper surface of a weir over which water flows is known is

The use of coarse screens for the disposal of sewage, may be dispensed with by

The use of tie plates in laced columns is

The useful moisture of soil, is equal to its

The usual percentages of clay and metal in cermet are:

The usual width of parapet walls along Highways in hilly region, is

The usual width of side drains along Highways in hilly region, is

The value of bulk modulus of a fluid is required to determine

The value of Chezy’s constant C = 157.6/(1.81 + K/√r) is used in

The value of coefficient of discharge is the value of coefficient of velocity.

The value of coefficient of velocity for a sharp edged orifice with the head of water.

The value of compression index for a remoulded sample whose liquid limit is 50% is

The value of energy quantum for radiation of any frequency is proportional to:

The value of geo-centric parallax to be added to the observed altitude of sun is

The value of mass density in kg-sec-V-m4 for water at 0°C is

The value of the coefficient of compressibility for water at ordinary pressure and temperature in kg/cm is equal to

The valve fitted closely in a recess against an opening in a pipe, is generally

The valves provided at low points of pipes to drain off water quickly under gravity, are called

The vane shear test is used for the in-situ determination of the undrained strength of the intact fully saturated

The vapour pressure over the concave surface is

The variation in the volume of a liquid with the variation of pressure is called its

The variation of atmospheric potential is caused due to:

The variety of pig iron used for manufacture of wrought iron, is

The variety of pig iron used for the manufacture of steel by Bessemer process, is

The various stages occuring in GPS system are described below:
1.      Generation of an output to the user
2.      Detection of the GPS signals
3.      Processing the data in the built-in-computer
4.      Decoding the GPS signal.
The correct sequence of the stages is:

The vehicle used in case of enamel paints is usually

The velocity at which the flow changes from laminar flow to turbulent flow is called

The velocity at which the laminar flow stops, is known as

The velocity corresponding to Reynold number of 2000 is called

The velocity corresponding to Reynold number of 2800, is called

The velocity of a moving body, is

The velocity of a moving body, is

The velocity of drainage water in the barrels of a syphon-aqueduct, is normally limited to

The velocity of flow does not depend on

The velocity of flow of water in a sedimentation tank is about

The velocity of jet of water travelling out of opening in a tank filled with water is proportional to

The velocity of the liquid flowing through the divergent portion of a Venturimeter

The velocity through a channel of circular section will be maximum when the depth of water is the diameter of the circular channel.

The vertical angle between longitudinal axis of a freely suspended magnetic needle and a horizontal line at its pivot, is known

The vertical distance between the springing line and highest point of the inner curve of an arch is known as

The vertical faces of a door opening which support frame of the door, are

The vertical member running through middle of a shutter frame, is

The vertical members fixed between steps and hand rail, are known

The vertical posts placed at the top and bottom ends of a flight supporting the hand rail are known as

The vertical side member of a shutter frame, is known