The vertical sides of a door and window openings provided in a wall, are known as

The viscosity of a liquid its rate of flow through a hole in a vessel.

The viscosity of water at 20°C is

The viscosity of water is than that of mercury.

The void ratio of

The void ratio of a soil sample decreases from 1.50 to 1.25 when the pressure is increased from 25 tonnes/m2 to 50 tonnes/m2, the coefficient of compressibility is

The volume is measured correct to the nearest

The volume of a fluid as the pressure increases.

The volumetric change of the fluid caused by a resistance is known as

The voussoir placed at crown of an arch, is known as a

The wall constructed for the stability of a back filling portion of a road on the downhill side, is known as

The wall constructed for the stability of an excavated portion of a road on the hill side, is known as

The walls which are necessary on the hill side of roadway where earth has to be retained from slipping is known as

The want of correspondence in stereo-photographs

The water carriage system of collection of waste product

The water carried sewerage system removes

The water content in a soil sample when it continues to loose weight without loosing the volume, is called

The water content of soil is defined as the ratio of

The water content of soil, which represents the boundary between plastic state and liquid state, is known as

The water face of the guide banks, is protected by

The water level in an open well was depressed by pumping 2.5 m and recuperated 2.87 m in 3 hours and 50 minutes. The yield of the well per minute is

The wavelength is computed by Bertin’s formula (where T is the period in seconds).

The weaving length of a roadway is the distance

The web crippling due to excessive bearing stress can be avoided by

The wedge shaped bricks forming an arch ring, are called

The wedging is adopted for quarrying costly stratified rock such as

The weight of 1 m3 of brick earth, is about

The weight of a foundation is assumed as

The weight of a good quality brick when immersed in water for a period of 16 hours should not
exceed the weight of dry brick

The weight of a pycnometer containing 400 g sand and water full to the top is 2150 g. The weight of pycnometer full of clean water is 1950 g. If specific gravity of the soil is 2.5, the water content is

The weight of an item is measured correct to nearest

The weight of reinforced concrete, is generally taken as

The weight of the rails depends upon

The weight of vehicles affects

The weight per unit volume of a liquid at a standard temperature and pressure is called

The Westergaard analysis is used for

The width and interval of transverse centre line bars along the extended centre line of runway, in approach lighting system are

The width formation of a road means the width of

The width of a beam of uniform strength having a constant depth d length L, simply supported at
the ends with a central load W is

The width of a dowla is generally kept between 30 to 60 cm and its height above the road level should invariably be more than

The width of a meander belt is the transverse distance between

The width of a rectangular sewer is twice its depth while discharging 1.5 m/sec. The width of the sewer is

The width of a settling tank with 2 hour detention period for treating sewage 378 cu m per hour, is

The width of different roads as recommended in Nagpur plan by the Indian Road Conference for hilly region, is

The width of foot for 90 R rail section is

The width of pavement in addition to a gravelled berm 1 m on either side for a two directional traffic recommended by Nagpur Conference of Chief Engineers, is

The width of road pavements, depends upon

The width of the analogous column in the method of column analogy is

The width of the entrances of the harbours is restricted to

The width of the flange of a L-beam, should be less than

The width of the flange of a T-beam should be less than

The width of the flange of a T-beam, which may be considered to act effectively with the rib depends upon

The width of the hollow space between two walls of a cavity wall should not exceed

The width of the rib of a T-beam, is generally kept between

The width of the right of way in urban area, is kept between 24 m to 60 m for

The width of the right of way, is influenced by

The window which is provided in flat roof of a room, is known

The window which is provided on a sloping roof of a building, is called

The window which projects outside a room of a building for admitting more light and air, is known

The working conditions in imhoff tanks are

The X-ray rooms are plastered with

The yield moment of a cross section is defined as the moment that will just produce the yield stress in

The yield of a rapid gravity filter as compared to that of slow sand filter, is

The yield strength and tensile strength of low carbon steel may be improved by the addition of

The Young’s modulus of elasticity of steel, is

The zenith is the point on the celestial sphere

The zero atmospheric pressure is at

The zero of the graduated circle of a prismatic compass is located at

The zone in which transverse bending is likely to occur may be obtained by drawing a line from the faces of the column making an angle 0 with horizontal where 0 ia

There are two stations A and B. Which of the following statements is correct?

Thickened part of a flat slab over its supporting column, is technically known as

Thickness of a pavement may be reduced considerably by

Thickness of broken centre line markings for a four lane road, is generally kept

Thickness of broken line markings on multi-lane road for lanes is generally kept

Though the effective depth of a T-beam is the distance between the top compression edge to the centre of the tensile reinforcement, for heavy loads, it is taken as

Three basic raw materials which are needed in large quantities for production of steel are

Three forces which act on a rigid body to keep it in equilibrium. The forces must be coplanar and

Three point problem can be solved by

Three points A, B and C 500 m apart on a straight road have 500 m, 505 m and 510 m as their reduced levels. The road is said to have

Through a point in a loaded soil mass, there exists V typical planes mutually orthogonal on which the stress is wholly normal and no shear stress acts, if V is

Through a point in a loaded soil, the principal stress is maximum on

Tie bars in cement concrete pavements are at

Tilt of the staff in stadia tacheometry increases the intercept if it is

Time and progress chart of a construction, is also known as

Time factor for a clay layer is

Time of concentration

Time period and length of a second’s pendulum respectively are

Time required to stop a car moving with a velocity 20 m/sec within a distance of 40 m, is

To achieve best performance, the type of switch preferred to, is

To ascertain the maximum permissible eccentricity of loads on circular columns, the rule generally
followed, is

To attain the synchronous orbit, the launch of a satellite, is done from a place

To avoid an interruption in the flow of a siphon, an air vessel is provided

To avoid bending action at the base of a pier,

To avoid large centering error with very short legs, observations are generally made

To avoid the damage of nose of crossing, the wing rails are ramped so that nose of crossing remains at a lower level by

To avoid vaporisation in the pipe line, the pipe line over the ridge is laid such that it is not more than

To compensate the loss of tractive force of vehicles along curves of radius R, the percentage reduction of gradient, is

To construct a 10 cm thick partition wall, you will prefer

To control the growth of algae in reservoirs, the compound which is used, is

To control the silt entry into a distributary at head regulator, King’s vanes are provided which are the walls