The forces in the members of simple trusses, may be analysed by

The forces which meet at one point and have their lines of action in different planes are called

The form work from the sides of beams can be removed only after

The form work from the slabs excluding props, can be removed only after

The form work from the underside of slabs, can be removed only after

The form Work including the props can be removed from beams, only after

The formation width for a double line Broad Gauge track in cutting (excluding drains) as adopted on Indian Railways is

The formation width for a railway track depends on the
(i)      Type of gauge
(ii)      Number of tracks to be laid side by side
(iii)     Slope of sides of embankment or cutting The correct answer is

The formation width for a single line meter gauge track in embankment as adopted on Indian Railways is

The formula for calculating the depth of concrete pavements suggested by Gold beck, is

The formula for the horizontal distances for inclined sights, on staff held normalis (f/i) s cos 0 + f + d cos 0 ± h sin 0

The formula HL = nzVzt/R4/3 for the head loss in conduits is generally known as

The formula Q = P – K [1.8T + 32] in which Q is runoff, P is annual rain fall in cm, T is mean annual temperature in centigrade and K is a constant, is known

The formula V = (1/n) r2/3 Vs used for determining flow velocities in sewers, is known as

The formula which accepts the value of rugosity coefficient n = 0.012 to be used in Manning’s formula, is given by

The foundation in which a cantilever beam is provided to join two footings, is known as

The foundation which consists of a thick reinforced cement slab covering whole area to support heavy concentrated structural loads, is known as

The foundations are placed below ground level, to increase

The four major water supply distribution systems, are

The frequency of oscillation on moon as compared to that on earth, will be

The frog of a brick is normally made on its

The frog of the brick in a brick masonry is generally kept on

The full width of land acquired before finalising a highway, alignment is known

The function of an expansion joint in rigid pavements is to

The function of cleats in a roof truss is

The function of king post in a king post roof truss is

The fundamental factor in the selection of pavement type is

The fuse large includes

The G.T. road from Lahore to Calcutta in undivided India, was constructed during

The gas evolved in sewers is

The gas from sludge digestion tank is mainly composed of

The gas which may cause explosion in sewers, is

The gaseous form of chlorine gets converted into liquid form when subjected to a pressure of

The general expression for the B.M. of a beam of length / is the beam carries M = (w//2) x – (wx2/2)

The GPS space segment consists of Navigation Satellite Timing and Ranging whose number is:

The grade compensation on B.G. tracks on Indian Railways, is

The grade of concrete M 150 means that compressive strength of a 15 cm cube after 28 days, is

The grade of concrete not recommended by I.S. : 456, is

The grade resistance factor for an earth moving machine can be obtained by multiplying grade percentage by a factor approximately equal to

The gradient of sewers depends upon

The gradient on which an additional engine is required to negotiate the gradient, is called

The gradients of trace cuts for hilly roads, are kept

The graphical method of determining the forces in the members of a truss is based on

The gravitational force makes a satellite go round the earth in a circular orbit, if it is projected with an initial velocity of

The great circle along which the sun appears to trace on the celestial sphere with earth as centre during the year, is called

The great circle which passes through the zenith, nadir and the poles, is known as

The great circle whose plane is perpendicular to the axis of rotation of the earth, is called

The greatest gauge of long rivets should not exceed (where d is the diameter of the holes).

The greatest load which a spring can carry without getting permanently distorted, is called

The greatest permissible clear dimension of the web of thickness t in the panel of a plate girder, is restricted to

The grit and silt of the grit chambers, may not be used for

The grit chambers of sewage treatment plants, are generally cleaned after

The gross diameter of a rivet is the diameter of

The gross section of the web of a beam is defined as

The ground surface slopes 1 in 50 along a proposed railway embankment 150 m in length. The height of the embankment at zero chainage is 0.5 m, the width is 11 m and side slopes 2:1. If the falling gradient of the embankment is 1 in 150, the quantity of the earthwork calculated by Prismoidal formula, is

The group index for a soil, whose liquid limit is 40 percent, plasticity index is 10 percent and percentage passing 75 micron IS sieve

The hammer blow in pipes occurs when

The hardest rock is

The harmonious mixing of the clay ingredients, is known as

The head against which the motor works for lifting water, is

The head against which the motor works for lifting water, is

The head light of vehicles should be such that its lower beam illuminates objects at

The head of public works department of any Indian state, is

The heaviest I-section for same depth is

The heaviest line is used to democrat

The height displacement on a vertical photograph

The height of a water column equivalent to a pressure of 0.15 MPa is

The height of the center of arm of a semaphore signal above the ground is

The height of the pilot’s eye above the runway surface is assumed

The height of the rail for 52 kg rail section is

The height of the sink of wash basin above floor level is kept

The high strength of rapid hardening cement at early stage, is due to its

The highest efficiency is obtained with a channel of section.

The highest line of sloping roof, where two opposite slopes meet, is known as

The horizontal angle between true meridian and magnetic meridian, is known

The horizontal angles from the boat between A and B and B and C, the stations on the shore are respectively 61 and 02. The distances AB = L1 and BC = L2. For calculating the angle a2 at C between the boat and station B is obtained by using the following formula: where 0 is horizontal angle between A and C at B).

The horizontal component of buoyant force is

The horizontal portion of a step in a stairs case, is known as

The horizontal timber piece provided at the apex of a roof truss which supports the common rafter is called

The hour angle of the heavenly body for Greenwich meridian equals the hour angle of the body for any other meridian + longitude:

The hourly variation factor is usually taken as

The Huygens telescope eye piece

The hydraulic gradient line lies over the centre line of the pipe by an amount equal to the

The hydraulic head that would produce a quick condition in a sand stratum of thickness 1.5 m, specific gravity 2.67 and voids ratio 0.67 is equal to

The hydraulic mean depth (HMD) for an egg-shaped sewer flowing two-third full is

The hydraulic mean depth for a circular pipe of diameter (d) is

The hydraulic mean depth or the hydraulic radius is the ratio of

The hydrometer method of sedimentation analysis differs from the pipette analysis mainly in

The ideal shape of a transition curve, is

The imaginary line drawn in the fluid in such a way that the tangent to any point gives the direction of motion at that point, is known as

The imaginary line passing through the intersection of cross hairs and the optical centre of the objective, is known as

The important component of a sea port is

The important test to be conducted on a stone used in docks and harbours is

The impurity of mixing water which affects the setting time and strength of concrete, is

The inclined support at the ends of treads and rises of a stair, is known as

The inclined surface of an abutment to receive the arch, is known as

The included angles of a theodolite traverse, are generally measured

The increase of temperature results in

The increased cohesiveness of concrete, makes it

The independent float affects only