Subscribe and get latest posts and study materials to your mail & dont forget to verify ur mail after subscription.

 
Enter your email address:

[Mock Test] All Syllabus Civil Engineering Mock Test – 3 – (100 Questions) for SSC JE, ESE, AE & PSUs exams




Welcome to your Civil Engineering Mock test - 3 (100 Questions)
Take an exciting test in Civil Engineering ( 100 Questions)
You have only 1 Hour mins to complete the test (100 Questions)
Wish you all the best!!!
Name
Email
1. If the engineer-in-charge approves, the 10 cm cubes may be used for the work test of concrete provided maximum nominal size of aggregate, does not exceed
2. In rigid module, the discharge
3. Reinforcement in cement concrete slab of road pavements, is placed
4. Flow through period, in sedimentation tanks, is
5. A land is said to be water-logged if its soil pores within
6. An earth formation which, although porous and capable of absoring water does not provide an appreciable supply to wells, is known as
7. Disinfection of water with ozone is not good because
8. An arch may be subjected to
9. A T-beam behaves as a rectangular beam of a width equal to its flange if its neutral axis
10. The maximum vacuum created at the summit of a syphon is
11. The phenomenon of slow extension of materials having constant load, i.e. increasing with the time is 
12. While calculating the sight distances, the driver's eye above road surface, is assumed
13. Saw dust can be rendered chemically inert by boiling it in water containing
14. The ideal shape of a transition curve, is
15. Efflorescence in cement is caused due to an excess of
16. The number of points of contraflexure in a simple supported beam carrying uniformly distributed load, is
17. The angle between two plane mirrors of optical square, is
18. If water table is comparatively high, the irrigation canal becomes useless, due to
19.
The compression index of a soil
20. Minimum thickness of a layer of fine sand required to cut off capillary rise of water completely, should be
21. The ratio of the rate of change of discharge of an outlet and parent channel, is known as
22. Mathamoglobinemia, or blue baby disease is caused due to
23. The water face of the guide banks, is protected by
24.
Lime mortar is generally made with
25. Unit of kinematic viscosity is
26. While determining the yield of open wells by the pumping test
27. The maximum bending moment due to a moving load on a simply supported beam, occurs
28. If the ratio of the span to the overall depth does not exceed 10, the stiffness of the beam will ordinarily be satisfactory in case of a
29. Most economical section of a circular channel for maximum discharge
30. Water cement ratio is
31. The shear stress distribution in viscous fluid through a circular pipe is :
32.
Cast iron contains carbon approximately
33.
The direct shear test suffers from the following disadvantage:
34. The side slope of Cipolletti weir is generally kept
35. The ratio of the head recovered to the head put in, is known as
36. A syphon is used
37.
Spirit varnish generally consists of
38.
The soil which contains finest grain particles, is
39. A pitot tube is used to measure
40.
Pick up the incorrect statement from the following:
41.
Acrylic is the name of
42. The ratio of maximum velocity to average velocity of viscous fluid through a circular pipe is
43. Minimum permissible speed on high speed roads, is decided on the basis of
44. In a three hinged arch, the shear force is usually
45. Increase in population of a rapidly growing city, may be estimated by
46.
Good quality cement contains higher percentage of
47. The thickness of a sharp crested weir is kept less than
48. The cement whose strength is a little lower than the ordinary cement during the first three months but attains afterwards the same strength, is known as
49. For structural analysis of forces, the method refers to
50. The law which states, "within elastic limits strain produced is proportional to the stress producing it", is known as
51. Percussion drilling is unsuitable in
52.
Number of piles required to support a column, is
53. For stairs spanning horizontally, the minimum waist provided is
54. On concrete roads, the camber generally provided, is
55. In a simply supported slab the minimum spacing of distribution reinforcement, should be four times the effective thickness of the slab or
56. The diameter of the Vicat plunger is 10 mm and its length varies from
57. An ideal transition curve is
58.
Plastic asphalt is
59.
The equation τ = C + σ tan φ is given by
60. The desirable camber for straight cement concrete roads, is
61. If a three hinged parabolic arch carries a uniformly distributed load on its entire span, every section of the arch resists.
62. The uplift pressure on the roof of an inverted syphon, is maximum when
63. The level of the fioor of a syphon aqueduct can be obtained
64. If the straight sides of a triangular section of a lined canal with circular bottom of radius D, make an angle θ with horizontal, the hydraulic mean depth is
65. The weight of a foundation is assumed as
66. The desired sensitivity of a bubble tube with 2 mm divisions is 30". The radius of the bubble tube should be
67. Two hill tops A and B 20 km apart are intervened by a third top C. If the top most contour of the three hill tops are of the same value, state whether the line of sight AB
68. Pantagraph is used for
69. In levelling operation
70. The live load to be considered for an inaccessible roof, is
71.
If σ0' and σ' represent initial and increased pressure ; e0 and e void ratios corresponding to initial and increased pressure ; and C0 the compression index (dimensionless), then, the virgin compression curve as expressed by Terzaghi empirical formula is
72. The momentum correction factor (β) for the viscous flow through a circular pipe is
73. Slump test of concrete is a measure of its
74. The condition not applicable to water cement ratio law, is
75. True meridian of different places
76. Surface water is obtained from
77. If the angular measurements of a traverse are more precise than its linear measurements, balancing of the traverse, is done by
78. Pick up the incorrect statement from the following:
79. According to IRC : 52-1973, for a single lane National Highway in hilly region,
80. The standard B.O.D. at 20&Deg;C, is taken for the consumption in
81. In an ideal transition curve, the radius of curvature
82.
For shear strength, triaxial shear test is suitable because
83. If the effective working time is 7 hours and per batch time of concrete is 3 minutes, the output of a concrete mixer of 150 litre capacity, is
84.
You are given a sample of soil containing coarse grains to determine its water content, you will use
85.
The yield strength and tensile strength of low carbon steel may be improved by the addition of
86. If x% is the gradient of an alignment and y% is the gradient after proper superelevation along a curved portion of a highway, the differential grade along the curve, is
87. Total pressure on the vertical face of a retaining wall of height h acts parallel to free surface and from the base at a distance of
88. For setting out a simple curve, using two theodolites.
89.
The tendency of a stone is, to split along:
90. The latitude of a traverse leg is obtained by multiplying its length by
91. The maximum shear stress (qmax) in a rectangular beam is
92. A cantilever beam rectangular in cross-section is subjected to an isolated load at its free end. If the width of the beam is doubled, the deflection of the free end will be changed in the ratio of
93.
For obtaining vinyl chloride acetate, the method used, is
94. The radius of a bar bend to form a hook, should not be less than
95.
The soil moisture driven off by heat, is called
96. The maximum resistance against rotation, is offered by the weld at a point
97. If the sides of a slab simply supported on edges and spanning in two directions are equal, the maximum bending moment is multiplied by
98. Normal values of overflow rate for plain sedimentation tank, is
99. Cross regulators in main canals are provided
100.
Steel contains carbon approximately







5 Comments on "[Mock Test] All Syllabus Civil Engineering Mock Test – 3 – (100 Questions) for SSC JE, ESE, AE & PSUs exams"

  1. Nice questions

  2. useful

  3. nice

  4. expected question

Comments are closed.

[NPTEL Notes PDF] Civil Engineering (105 Courses in PDF Format)

Ships within 5 days | ₹ 1,250 Only.

This is the one time cost you spend for getting very good quality notes PDF for preparing any kind of Competitive exams. 

Subscribe and get the latest posts and study materials to your mail!

Enter your email address:

Delivered by FeedBurner

Those who are subscribed our web, kindly verify your mail received by you. Those who are verified, kindly ignore this message.

// hide the meta tag generator from head and rss function disable_meta_generator() { return ''; } add_filter('the_generator','disable_meta_generator'); remove_action('wp_head', 'wp_generator');