Building Construction Mock test – 5 || Civil Engineering Mock tests - ENGINEERING BIX

Building Construction Mock test – 5 || Civil Engineering Mock tests




Welcome to your Building construction Mock test - 5
Take an exciting test in Building Construction
You have only 20 mins to complete the test (25 Questions)
Wish you all the best!!!
Name
Email
1. The form Work including the props can be removed from beams, only after
2. The ceiling height of a building is
3. In flat roof of reinforced cement concrete, the recommended angle of slope, is
4. The bearing capacity of granite is generally
5. The maximum permissible deflection of a timber beam supporting a roof, is
6. The mortar in which both cement and lime are used as binding materials, is called
7. The rock formed from the solidification of molten matter (magma) is called:
8. Pick up the incorrect statement from the following:
9. The nominal thickness of one brick wall in mm, is
10. The opening provided in sloping roof with its top parallel to the roof surface, is called
11. The window which is provided in flat roof of a room, is known
12. The stepped structure provided for lateral support of a structure, is
13. To stagger vertical joints in successive courses of a wall, a piece of brick is generally used at the  end of the course, which is known as
14. The skirting/dado in a bath roof should be upto
15. The pile which supports the load partly by friction and partly by resting on hard stratum, is called
16. The vertical sides of a door and window openings provided in a wall, are known as
17. The depth of the ground water table may be ascertained by
18. In grillage foundations a minimum 15 cm cover is provided on
19. The single stage well point system of dewatering an excavation can be used if the depth of excavation does not exceed
20. The highest line of sloping roof, where two opposite slopes meet, is known as
21. The process of working a flat for the finishing coat, is known
22. The type of ashlar masonry in which stones are finely chisel dressed and thickness of joints does not exceed 3 mm, is
23. Dampness causes
24. Engineering news formula for obtaining safe bearing capacity of pile for drop hammer, is,
25. The window which is provided on a sloping roof of a building, is called







Share to all