Subscribe and get latest posts and study materials to your mail & dont forget to verify ur mail after subscription.

Enter your email address: Delivered by FeedBurner

Building Construction Mock test – 3 || Civil Engineering Mock tests

Welcome to your Building Construction Mock test - 3
Take an exciting test in Building Construction
You have only 20 mins to complete the test (25 Questions)
Wish you all the best!!!
1. If the depth of an excavation is 20 metres, number of single stage well points to be installed at  various levels, is
2. Dado is usually provided in
3. The form work from the underside of slabs, can be removed only after
4. The line of intersection of the surfaces of a sloping roof forming an external angle exceeding 180°, is
5. The 9 cm × 9 cm side of a brick as seen in the wall face, is generally known as
6. The depth of an arch is the distance between
7. The foundation in which a cantilever beam is provided to join two footings, is known as
8. For heavy embankments and dams, of height h, the depth of exploration of soil should not be less  than
9. The range of spread from the wall base to outer edge of a brick work foundation does not exceed
10. The projections of head or sill of a door or window frame are
11. A projecting piece usually provided to support a truss, is
12. A roof which slopes in four directions, is called
13. The nominal thickness of an expansion joint in brick walls, is kept more than
14. The vertical members fixed between steps and hand rail, are known
15. Couple roof is used for spans
16. The vertical member running through middle of a shutter frame, is
17. The minimum thickness of walls built in cement mortar (1 : 6) for a single storey building, is
18. Pick up the commonly adopted geophysical method in civil engineering from the following:
19. The depth of excavation of foundations, is generally measured with a
20. The taper of precast concrete pile should not be more than
21. Best type of piles for soft soil having little resistance to the flow of concrete, is
22. Exposed portions of vertical surface at right angles to the door or window frame, are known as
23. The lower half portion between crown and skew back of the arch, is called
24. The alignment of a cross joint along the plumb line is
25. If height of the first storey of a building is 3.2 m and riser is 13 cm, the number of treads required,  is

Share to all

Be the first to comment on "Building Construction Mock test – 3 || Civil Engineering Mock tests"

Leave a comment

Your email address will not be published.


Subscribe and get the latest posts and study materials to your mail!

Enter your email address:

Delivered by FeedBurner

// hide the meta tag generator from head and rss function disable_meta_generator() { return ''; } add_filter('the_generator','disable_meta_generator'); remove_action('wp_head', 'wp_generator');